Selecting the on-screen display language, Getting started, Step 2: connect the power cord – Sony GDM-500PST9 User Manual

Page 7: Step 3: turn on the monitor and computer

Advertising
background image

7

Getting Started

Getting Started

FR

DE

ES

GB

IT

Automatically Adjusting the Size
and Centering of the Picture

By pressing the auto sizing and centering (ASC) button, the
size and centering of the picture are automatically adjusted
to fit the screen.

1

Turn on the monitor and computer.

2

Press the ASC button.
The picture is adjusted to fit the center of the screen.

Notes

• This function is intended for use with a computer running

Windows or similar graphic user interface software that
provides a full-screen picture. It may not work properly if the
background color is dark or if the input picture does not fill the
screen to the edges (such as an MS-DOS prompt).

• The screen may go blank for a few seconds while performing the

auto-sizing function. This is not a malfunction.

• Although the signals for picture aspect ratio 5:4 (resolution: 1280

×

1024) do not fill the screen to the edges, the picture is

accurately displayed.

Selecting the On-screen Display
Language

If you need to change the OSD language, see “Using the
LANG (Language) On-screen Display” on page 17.
The default setting is English.

Step 2: Connect the power cord

With the monitor switched off, connect one end of the
power cord to the monitor and the other end to a power
outlet.

Step 3: Turn on the monitor and computer

The installation of your monitor is complete.

Note

If “OUT OF SCAN RANGE” or “NO INPUT SIGNAL” appears on
the screen, see “Warning Messages” on page 20.

For customers using Windows 95/98

To maximize the potential of your monitor, install the new model
information file from the supplied Windows Monitor Information
Disk onto your PC.
This monitor complies with the “VESA DDC” Plug & Play
standard. If your PC/graphics board complies with DDC, select
“Plug & Play Monitor (VESA DDC)” or this monitor’s model name
as the monitor type in the “Control Panel” of Windows 95/98.
If your PC/graphics board has difficulty communicating with this
monitor, load the Windows Monitor Information Disk and select
this monitor’s model name as the monitor type.

For customers using Windows NT4.0

Monitor setup in Windows NT4.0 is different from Windows 95/98
and does not involve the selection of monitor type. Refer to the
Windows NT4.0 instruction manual for further details on adjusting
the resolution, refresh rate, and number of colors.

ASC

to a power outlet

to AC IN

Power cord (supplied)

Advertising