Samson MDR 6 - Manual (Page 2)

MDR 6
PRODUCT SPECIFICATION SHEET
SERIES DESCRIPTION CATEGORY
MDR MIXER MIXERS
MDR 6 SPECIFICATIONS
Frequency Response (Trim @ Min, unity gain +0/-1dB)
Mic to Main ........................ 10 Hz - 30 kHz
Line to Main ....................... 10 Hz - 30 kHz
Aux Return to Main ............. 10 Hz - 30 kHz
Line to Aux Send ................ 10 Hz - 32 kHz
T.H.D. (Trim @ Min, +4dBu output, unity gain, 1 kHz w/30 Hz LPF)
Mic/Line to Main(Mono Ch) ... 0.02%
Line to Main (Stereo Ch) ...... 0.02%
Line to Aux Send ................ 0.02%
Equivalent Input Noise (“A” filter on, input shorted)
Mic ................................... -128 dB
Line .................................. -104 dB
Maximum Voltage Gain
Mic to Main ........................ 74 dB
Line to Main (Mono Ch) ....... 56 dB
Line/Tape to Main (Stereo Ch) 34 dB
Aux Return to Main ............. 20 dB
Mic to Aux Send ................. 74 dB
Line to Aux Send (Stereo Ch) ... 34 dB
Residual Noise (30 kHz LPF, all control Min)
Main .................................. -89 dBu
Aux Send ........................... -86 dBu
Crosstalk (@ 1 kHz w/ 30 kHz LPF)
Ch vs. Ch ........................... -75 dB
Input vs. Output ................. -87.5 dB
Peak LED Sensitivity
(before clipping) ................. 5 dB
CLIP Indicators ................................ Turn on: THD> 0.1%
Headphone output (600 ohm load) ..... 100 mW
Maximum Input Level (1 kHz, Ch. & Mix fader set to 0)
Mic Input (Mono Ch) ........... +11 dBu
Line Input (Stereo Ch) ......... +27 dBu
Input Channel Equalizer (± 2dB)
High (shelving) ................... 12 kHz ±15 dB
Mid (peaking) ..................... 2.5 kHz ± 15 dB
Low (shelving) .................... 80 Hz ±15 dB
Meters ............................................ 5 POINT LED METERS (-20,
-6, 0, +6dB and PEAK)
Phantom Power ................................ +48V
Power Requirement .......................... 110V-240V, 50/60Hz
Power Consumption .......................... 19 watts
Dimensions (W x D x H) .................... 9” x 10 3/4” x 3 1/2”
(229mm x 273mm x 89mm)
Weight ............................................ 4.5lbs (2.1kg)
ARCHITECT’S & ENGINEER’S SPECIFICATIONS
The Samson MDR6 shall be a 6 input, stereo output mixer.
It shall have 2 mic channels with trim controls, HF, MF,
and LF equalizer controls, 1 aux send, pan control and a
60mm fader. It shall have 2 mic/line stereo channels with
all the same controls as the mic channels except for the trim
control. 60mm left and right output faders will be available.
Each channel shall have a REC button which when pushed
(along with the Hard Disk button in the master section)
allows that channel’s output to be sent through the 2TK
output and to a computer for recording without getting a
loop. A mono output with level control shall be provided. A
control room and headphone output and level control shall
also be provided. The MDR6 uses an external power supply.
229 mm
273 mm
89 mm