Sanus Systems NF213 - Manual (Page 3)

Step 2: Attach Rear Supports
NOTE: The Rear Supports (E) must be positioned with set of three holes closest to the edge toward the top and the
horizontal slots facing the Front Frame (A).
Thread an Allen Bolt ( I) through a Washer (J), the middle hole in a Rear Support (E), the middle hole in a Three Hole Plate
( C), and into the middle Steel Cross Tube (B), as shown in Diagram 2. Repeat this procedure until all four middle Allen Bolts,
accompanying Washers, and Rear Supports are attached to the middle Steel Cross Tubes.
Thread an Allen Bolt ( I) through each hole of the Wire Straps (H), the Rear Supports (E), each outer hole of the Three Hole
Plates ( C), and into the outer Steel Cross Tubes (B) as shown in Diagram 2.
Using the Allen Key ( M), tighten all twelve Allen Bolts (I).
Diagram 2
C
Three holes near
edge toward top.
Horizontal
Slot
H
I
J
E
B
I
Step 3: Install Glass Shelves
NOTE: Make sure the round edges of the Glass Shelves are to the sides and the flat edge fits into the horizontal
slot in the Rear Support.
Install the Glass Shelves ( D) so the back of each Glass Shelf fits into the horizontal slot in the Rear Support (E), and the
front of the Glass Shelf sits down into the groove in the Front Frame ( A) as shown in Diagram 3.
Diagram 3
D
A
E
Horizontal
Slot