Sears 200.71987 - Manual (Page 7)

• 5 •
12V DC Electrical Device Run-Time Chart
Appliance Type Estimated Power Estimated
Time*
Fluorescent Lights, Cellular Phones 4 Watts 40 Hours
Radios, Depth Finders, Fans 9 Watts 21 Hours
Camcorders, DVD Players, Spotlights 15 Watts 12 Hours
Electrical Tools, Bilge Pumps 24 Watts 7 Hours
Electric Coolers 48 Watts 3 Hours
Air Compressors, Car Vacuums 80 Watts 1.5 Hour
*NOTE: Estimated run-times. Actual time may vary. Times are based on
the internal battery being new, fully charged and operated at room tem-
perature.
USINg THE USb PORT 7.
The USb port on the 950 provides up to 500mA at 5VDC
Turn the JUMP START ON/OFF switch to the ON position.
7.1
Plug the device into the USB port on the front panel of the 950. 7.2
Turn USB device ON. 7.3
Reverse these steps when finished using the USB port. 7.4
USINg THE bUILT-IN LIgHT 8.
Position the 950 on a flat, stable surface near the intended work area. 8.1
Push the power switch to the LIgHT position. The light will turn on and 8.2
illuminate your work area.
NOTE: With a fully charged internal battery, the built-in light should pro-
vide 18 to 30 hours of continuous, useful light.
Push power switch to the OFF position when work is completed.
8.3
Charge the 950 as soon as possible after using the built-in light. 8.4
INTERNAL bATTERY REPLACEMENT 9.
The 950 is equipped with a built in door, located on the back of the unit, to
make replacing the internal battery easy and efficient.
To order a replacement battery, call: 1-800-SEARS-64
Be sure that all switches are in the OFF position.
9.1
Remove clamps from storage pegs on the back of the 950. 9.2
Remove eight screws from the door. 9.3
Slide door out. 9.4