Star Micronics TCP2000 Series - Manual (Page 10)

8
Cleaning switch
Front cover
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
CLEANING
6-1 Using the cleaning card
Two cleaning cards and one bottle of cleaning liquid for cleaning the mag-
netic head, rollers, etc. are supplied in the enclosed plastic bag.
(1) Dimensions of cleaning card
(2) Frequency of cleaning
1. Daily or every 300 times of printing.
2. When read/write errors occur continuously, or print quality gets low.
(3) How to use
1. Open the Front Cover and push the Cleaning Switch.
2. Apply penetration of the cleaning liquid to the felt surfaces (both sides)
of the cleaning card.
3. Insert the cleaning card from the card slot.
4. Allow the system approximately 1 minute for drying.
5. Ethel alcohol solvent may also be applied for cleaning.
IMPORTANT!
Do not use the bent cleaning card.
Bent card will cause a card jam.
85.6
89.6
22.0 54.0
Felt surface
Felt surface
Unit : mm
6