Sunbeam Bedding HE2100 - Manual (Page 9)

7
Using the Oscillation Function
The 90 degree oscillation function can be
used in any mode except standby.
1. Press the oscillation button (OSC),
positioned on the top of the heater. The
heater will then begin to oscillate from side
to side.
2. To stop the heater from oscillating, simply
press the oscillation button (OSC) once
again.
Resetting the Total Safety System
Resetting the safety auto shut-off
The safety auto shut-off detects any
abnormally high temperatures within the heater
and shuts it off to prevent overheating. Should
the safety auto shut-off activate and switch off
the heater, it will need to be reset.
1. To reset the heater, press the mode button
until the standby mode is selected.
2. Unplug the heater and wait 10 minutes for
the unit to cool down.
3. After 10 minutes, plug the heater in again
and operate as usual.
Resetting the thermal backup device
In addition to the safety auto shut-off, your
heater also contains a thermal back-up
device for additional protection. Should the
thermal back-up device activate and switch
off the heater it will need to be reset.
To reset the heater, follow steps 1 to 3 on
this page.