0dlqwhqdqfh, Xeulfdwlrq, Duh ri <rxu 'u\hu – Speed Queen 51206ZKZ User Manual

Page 15: 0rwru 2yhuordg 3urwhfwru

Advertising
background image

-15-

512062

DRY2024N

0DLQWHQDQFH

/XEULFDWLRQ

All moving parts are sealed in a permanent supply
of lubricant or are equipped with oilless bearings.
Additional lubrication will not be necessary.

&DUH RI <RXU 'U\HU

'U\HU ,QWHULRU

Wipe the surfaces using a soft cloth and
household cleaner or a non-abrasive paste of
powdered laundry detergent and hot water,
followed by a short heat cycle with a load of rags.

To remove crayon or ball point ink off the dryer
drum, put the heat on high and use old rags in the
dryer to absorb the crayon or ink. If unsuccessful,
contact the appliance dealer. DO NOT use any
chemicals in the dryer.

IMPORTANT: The use of chlorine bleach for
removing any discolorations should be avoided
because bleach could damage the finish.

&DELQHW

Wipe the dryer cabinet as needed. If detergent,
bleach or other washing products have been
spilled on the dryer, wipe immediately. Some
products will cause permanent damage if spilled
on the cabinet.

&RQWURO 3DQHO

Use only a damp or sudsy cloth for cleaning the
control panel. Some spray pretreat products may
harm the finish on the control panel.

NOTE: The wiring diagram is located inside the
control panel.

([KDXVW 6\VWHP

The exhaust duct should be inspected after one
year of use and cleaned if necessary. Inspect and
clean exhaust duct every one to two years as
required thereafter.

The weather hood should be checked frequently to
make sure the dampers move freely, dampers are
not pushed in and that nothing has been set
against them.

Keep dryer area clear and free from combustible
materials, gasoline and other flammable vapors
and liquids.

Do not obstruct the flow of combustion and
ventilation air.

NOTE: Verify proper operation after servicing.

0RWRU 2YHUORDG 3URWHFWRU

The dryer’s motor overload protector stops the
motor automatically in the event of an overload.
After cooling, the overload protector will reset
itself. Dryer can be restarted by pushing the
timer knob in. If overload protector cycles again,
remove the dryer from use and call the service
person to correct the problem.

7R UHGXFH WKH ULVN RI DQ HOHFWULF VKRFN

VHULRXV LQMXU\ RU GHDWK GLVFRQQHFW WKH

HOHFWULFDO VHUYLFH WR WKH GU\HU EHIRUH

FOHDQLQJ WKH LQWHULRU

W132

:$ 5 1 , 1 *

7R UHGXFH WKH ULVN RI HOHFWULF VKRFN

GLVFRQQHFW WKH HOHFWULFDO VHUYLFH WR WKH

GU\HU EHIRUH FOHDQLQJ

W043

:$ 5 1 , 1 *

Advertising