Snapper 1691531 - Manual (Page 4)

20. Remove the upper and lower dash hardware as
follows.
a. Remove the screws (C, figure 6) and washers.
b. Raise the hood and loosen the two screws, plain
washers, dished washers and nuts from front side
of dash (see figure 8).
c. Remove four and washers securing
lower dash.
d. Both dashboards can now be lifted up for access to
wiring.
21. Remove the ignition switch by removing nut. Retain
lockwasher for reinstallation.
22. Reach thru the hole in top of lower dash and install
the switch (A, I). Position the switch so that
slot in threads is up. From outside the dash, place the
washers
on switch, aligning tab washer in slot in
F i g u r e 6 . T r a c t o r D a s h
threads. Install and tighten the nut securely.
A . W o o d B l o c k : H a m m e r C . S c r e w s
23. Connect black switch wire to white wire from
ignition switch with connector 1) provided
Pry off the throttle control knob by using a claw in kit.
hammer and block of wood as shown in 6.
Remove throttle cable from left-side engine clamp.
Lift up lower dash and locate taptite screw securing
black ground wires. Route green wire (C, figure.
Loosen and washer that secures throttle 1) from switch and ground under this screw.
cable to intake manifold. Note pinch mark on cable
before removing from under capscrew. Cable must
25. Route the yellow and red wires from switch down
be reinstalled in same position for correct RPM
behind the steering shaft. Wires should follow wiring
settings. Remove cable from engine.
harness and be routed cut lower dash cutout,
19. Remove nut (A, flatwashers (B) and
underneath shift quadrant panel and thru square,
(C) securing steering wheel to shaft. Pull
hole for seat latch. Refer to figure 5. Wires should
steering wheel off shaft.
then be attached to wire clip (D, figure 5).
26. Connect the yellow wire to yellow wire from cylinder.
Connect the red wire to the red wire from cylinder.
27. This completes installation of the kit. Make the
following test to see if installation is correct.
Figure 7. Steering Wheel
A, Locknut
Flat Washers
C.
D. Steering Wheel
E. Cap
a. Reinstall ignition switch with nut.
b. Connect the battery cables negative cable last.
Turn the ignition switch to ON.
d. Flip the switch up, the lift arm should go back.
Flip the lift switch down, the lift arm should go
forward.
f. If switch does not check OK, disconnect the
battery cables, Then go thru the instructions and
make sure all connections are tight.
g. Reconnect the battery cables to perform above
test again. Before proceeding with following
instructions, disconnect the battery cables.
28. Reinstall lower dash with four capscrews and
washers. Position the upper dash the fuel tank.
Install the original hardware (figure 8).