Samsung SCX-4100 - Manual (Page 62)

62
PictBridge
You can use the USB cable to connect this camera to a printer that supports PictBridge (sold
separately) and print the stored images directly. Movie clips and voice files cannot be printed.
Connecting the Camera to a Printer
1. Press the POWER button to turn on the camera.
2 In a mode with the exception of Voice Recording mode,
press the MENU button.
3. Press the LEFT/ RIGHT button and select [SETUP]
menu tab.
4. Select [USB] menu by pressing the UP/ DOWN button
and press the RIGHT button.
5. Select [PRINTER] menu by pressing the UP/ DOWN
button and press the OK button.
6. Press the menu button twice and the menu will disappear.
7. Use the supplied USB cable to connect the camera to the printer as shown below.
8. Turn on the printer to connect the camera to the printer.
If [COMPUTER] is selected at step 5, the camera will not connect to the printer, and the auto-
focus lamp will just blink green.
If this happens, disconnect the USB cable and start over from step 2.
SETUP
RESET
CARD SEL.
USB
BACK: SET:OK
COMPUTER
PRINTER