Samsung HL-P4674W - Manual (Page 7)

• For replacement, you will need a 5.91 Inches-long Phillips screwdriver and a pair of gloves.
1 Unplug TV, then use a screwdriver
to remove the screw as shown in
the picture.
(Remove the rubber cap and
unscrew the screw. )
2 Remove the Lamp cover.
(Exert a bit of force to the right
and pull for easy opening.)
3 Use a screwdriver to remove the
screws securing the Lamp.
There are 2 screws: one on the
left and one on the right. When
the screws have been completely
unfastened, they will still be
connected to the body of the
Lamp.
4 Separate the Lamp from the
engine by holding the handle and
pulling it out.
5 To reinstall the Lamp, follow these
steps in reverse order.
NOTES
• Be sure the replacement Lamp is the same type.
• After replacing the lamp, align the lamp cover with the groove and secure the screws.
• The TV will not turn on if the lamp cover is not correctly closed (as this will activate the protective
circuit).
English - 7
BP68-00423A-00(02~13) 9/2/04 4:08 PM Page 7