Sinar m 493.03.000 - Manual (Page 6)

Sinar m
Configurations
14. Connect the Sinarback with the Macintosh computer via firewire- or
fiber optics cable, depending on the type of the Sinarback.
15. Plug the 12 volt power supply in the corresponding socket on the rear
side of the Sinar m and on the mains supply.
When using a Sinarback with fiber optics interface and a Power-
Optics Master cable, the wide J14 plug has to be plugged into the
socket of the adapter plate.
16. Plug the flash sync cable in the X sync socket on the front of the
Sinar m and on your flashlight unit. When using a Sinarback with fiber
optics interface and a PowerOptics Master cable, this cable can also
be plugged in the respective socket of the PCI Board 2, too.
17. Start the Macintosh computer.
18. Switch on the Sinar m by pushing the on/off switch forwards for about
two seconds (confirmed with an acoustic signal).
19. When using a Sinarback with fiber optics interface, the option “Back
Power Supply” must be activated in the Sinar m in order to supply the
Sinarback with power.
20. Start now the Sinar CaptureShop™ software.
➤
Your camera is now ready to work.
6 7
Diagram 9: Sinar m with mirror module and Sinarback (fiber optics)
Diagram 8: Sinar m with mirror module and Sinarback (firewire)