Samsung SP-D300B User Manual

Page 11

Advertising
background image

normal operating

condition.

Action 3

When temperature inside

of the projector becomes

too high.

Adjust the installation state of your projector by referring to the

Installation Precautions section listed above. Cool down your

projector sufficiently and then operate it again. If the same problem

occurs continually, contact your product distributor or

service center

.

Action 4

When the color wheel fails to

operate.

Disconnect and reconnect the power cord and start the projector

again. If the same symptom still occurs, contact your product

distributor or

service center

.

Action 5

The lamp

malfunctions after power

turns off

abnormally or after

powering on right after

turning off the projector.

Turn the power off, wait for a sufficient amount of cooling time and

then turn the power on to operate. If the same problem occurs

continually, contact your product distributor or

service center

.

Action 6

When the screen becomes

darker

Check the lamp usage time on the Information Display screen. If you

need to replace the lamp, contact your product distributor or

service

center

.

This Projector uses a cooling fan system to keep the unit from overheating. Operation of the cooling fan may

cause noise, which does not affect the product performance and is part of normal operation.

Rear Side

1. RS-232C port (For service input terminals)

2. SERVICE Input port

3. VIDEO IN Input port

4. S-VIDEO IN Input port

5. Remote Control Signal Receiver

6. HDMI/DVI IN Input port

7. MONITOR OUT terminal

8. PC IN Input port

9. COMPONENT IN Input port

10.POWER Input port

Advertising