Servis-Rhino SR15M - Manual (Page 91)

OPERATION
OPERATION
Operation Section 4-7
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
2.4 Drawbar
Pintle Hook Hitch-Optional Equipment
Drawbar length must be modified to obtain dimension
"A" (CV Driveline = 17" ± 2", Standard Driveline = 19”
± 2" ).
P i n t l e
Hook
Drawbar
Pintle Hook
Mount
PTO
Shaft
Tongue
Cont. Rod
P i n t l e
Clevis
Tongue
A
Constant Velocity and Standard Driveline
Equal Angle Driveline Adjustment Procedure
(Not available on 1000 RPM 1-3/4”-20 mowers)
Set drawbar length measured from PTO shaft end to hitch hole at 14” for 540 and 16” for
1000 RPM operating speeds. Position carrier bearing to align driveline in as straight of line as possible. Make
certain that the Yokes on the Driveline and the Equal Angle Jackshaft are aligned with each other, otherwise the
drivelines will not phase properly, possibly causing damage to your machine.
Tractor Drawbar Length
(Based on Mower Operating Speed)
16" (1000 RPM 1-3/8”-21)
20” (1000 RPM 1-3/4”-20)
TONGUE
DRAWBAR
14" (540 RPM 1-3/8”-6)
Position the length of the drawbar from the end of the
tractor PTO shaft to the drawbar hitch hole according
to the operating speed of the mower. If the mower is
a 540 RPM unit, position the drawbar length from shaft
end to hitch hole at 14”. For 1000 RPM mowers, set
the drawbar length at 16” for 21 spline 1-3/8” mowers
and at 20” for 1-3/4” 20 spline mowers.
(540 RPM 1-3/8"-6)
(1000 RPM 1-3/8"-21)