System Works 99101100 - Manual (Page 7)

REV. F 5-1-01 7 P/N 99101100
8. Remove the CARTRIDGE ELEMENT assembly from the filter body by using the lifting handles and
pulling straight up.
9. Remove the CARTRIDGE ELEMENT from the core assembly by placing your middle fingers into
cloth area and using your thumbs on top of the lifting handles and pressing until the CARTRIDGE
ELEMENT is loose and freely slides off the center core assembly.
10. Using a garden hose, direct water spray at the CARTRIDGE ELEMENT to dislodge and wash away
any accumulated foreign matter and Diatomaceous Earth. Thoroughly clean the elements.
11. Clean and remove debris from the inside of the filter tank.
12. Replace the CARTRIDGE ELEMENT over the center core assembly making sure the end of the
element with the wording ‘This Side Up’ is facing up.
13. Replace the CARTRIDGE ELEMENT into the filter tank body making sure the arrow on the top of
the center core is aligned with the filter inlet port. You will be able to feel the assembly drop into
and lock into place when in the proper position.
14. Clean any debris from the O-ring at the top of the filter tank. Apply a silicone lubricant to the O-ring.
DO NOT USE A PETROLEUM-BASE LUBRICANT ON THE O-RING.
Failure to properly clean and lubricate the O-ring may result in water leakage.
15. Replace the filter tank lid making sure it is fully and firmly seated on the tank body.
16. Place the filter lock ring over the filter lid, and turn clockwise until the safety latches click and the
lock ring hits the stops on the body.
DO NOT ATTEMPT TO OVER TIGHTEN THE FILTER LOCK RING AFTER THE SAFETY LATCHES HAVE
ENGAGED.
17. Replace the drain cap hand tight only.
18. Follow Initial Start Up and System Restart Instructions; see Section V.
WARNING
If the filter lock ring is damaged, replace it immediately.
This filter operates under high pressure. Replace locking ring if damaged or worn. Failure to
replace locking ring can result in the lid separating from the filter which can cause severe
injury or death.
WARNING
Failure to operate your filter system or inadequate filtration can cause poor water clarity obstructing
visibility in your pool. Poor water clarity may obscure objects in the water which while swimming and
diving could cause severe personal injury and death. Never swim in a pool with poor water clarity.