Sierra Wireless AirCard 710 - Manual (Page 45)

Rev 1.2 Mar.02 37
Re
g
u
la
to
ry
I
n
fo
rm
a
ti
o
n
9: Regulatory Information
Tested to comply with FCC standards
FOR HOME OR OFFICE USE.
This device complies with Part 15 of the FCC Rules. Operation
of this device is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesirable operations.
CAUTION When the AirCard 710/750 is in use, users should
maintain a distance of at least 25 mm (1”) between the antenna
and any part of the body. This device has been tested for
compliance with FCC RF exposure limits in a typical laptop
computer like the IBM ThinkPad T21 laptop PC used in the
grant application. This device is only authorized to be used
in a typical laptop computer, such as the one used in the
grant application.
FCC ID: N7NAC710 (for the AirCard 710); N7NAC750 (for
the AirCard 750).
Industry Canada #: 2417332343A (for the AirCard 710);
2417C11897 (for the AirCard 750).
Where appropriate, the use of the equipment is subject to the
following conditions:
CAUTION Unauthorized modifications or changes not
expressly approved by Sierra Wireless, Inc. could void
compliance with regulatory rules, and thereby your authority
to use this equipment.
WARNING (EMI) – United States FCC Information – This
equipment has been tested and found to comply with the
limits pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful
interference in an appropriate installation. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions,
may cause harmful interference to radio communication.
However, there is no guarantee that interference will not occur
in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and
receiver