Not for reproduction, Maintenance – Snapper 8.5 TP User Manual
Page 20
Page 20
PROBLEM
REMEDY/ACTION
Belts squeal in neutral and/or reverse
s
Adjust forward belt guide:
turn engine off and allow
to cool
- disconnect spark plug wire and secure from spark plug
- remove belt guard
- pull down on drive safety control levers
- manually bend forward belt guide so there is 1/16 inch
or less clearance between belt guide and belt
- replace belt guard and spark plug wire
Belts squeal in forward operation
s
Adjust tabs on the reverse belt guide
turn engine off and allow
to cool
- disconnect spark plug wire and secure from spark plug
- release drive safety control levers to neutral position
- remove belt guard
adjust tabs of reverse belt guide:
while drive safety control levers are released, bend
metal tabs on reverse belt guide to 1/64 inch or less
clearance from reverse belt
- replace belt guard and spark plug wire
Excessive heat build up in transmission/tine
area during tilling
s
Remove vegetation by following instructions in Clean
Tine Axle Shaft of Normal Care section.
FOLLOW ALL SAFETY INSTRUCTIONS
s
Check transmission
and
if needed
Maintenance
-
-
-
Not
for
Reproduction