Stamina Products 55-1772 - Manual (Page 11)

ASSEMBLY INSTRUCTIONS
11
STEP 11
Refer to illustration A. Tie the STRAP to the plug end of the PULSE SENSOR WIRE(27). Pull the STRAP
from the square hole on the top of the UPRIGHT(6) until the PULSE SENSOR WIRE(27) is pulled through
and extends out of the square hole. Attach the STATIONARY HANDLEBAR(7) to the UPRIGHT(6) with
BUTTON HEAD BOLTS(M8x1.25x15mm)(65), ARC WASHERS(M8)(87), and LOCK WASHERS(M8)(89).
STEP 12
Refer to illustration B. Install two AA batteries into the METER(26). Two batteries are included. See page 14
for detailed battery installation instructions. Connect the PULSE SENSOR WIRE(27) and CONNECTION
WIRE (29) to the METER(26). Slide the METER(26) onto the plate on the UPRIGHT(6).
CAUTION: Be careful not to damage the PULSE SENSOR WIRE(27) and CONNECTION WIRE(29) when
sliding the METER(26) .
Strap
A. B.