Sony DDM-2800CSU - Manual (Page 4)

4
Rear panel
Location and Function of Controls
1
R/G/B VIDEO IN (input) connectors (BNC type)
Inputs the R (red), G (green) and B (blue) signals. The
connectors are terminated at 50 ohms.
2 LANDING SENSOR connector (8 pin)
∗
This connector is used when adjusting uneven color by
connecting the optional DDM-LS10 landing sensor.
3 I/F (interface) connector (D-sub 15 pin)
∗
This connector is used when externally controlling
brightness, contrast, etc., and adjusting distortion,
convergence, color temperature, etc. by connecting the
optional DDM-RM10 controller.
∗ Adjustments 2 and 3 are performed by a service engineer.
Should the adjustment be required, please consult a Sony
representative.
4
MAIN circuit breaker
Set this circuit breaker to the I (on)
position when using this unit.
5 HD (horizontal drive) input connector (BNC
type)
Inputs horizontal drive pulses (HD). The connector is
terminated at 75 ohms.
6
VD (vertical drive) input connector (BNC type)
Inputs vertical drive pulses (VD). The connecter is
terminated at 75 ohms.
FAILURE indicator
ROTATION control
AC IN socket
7
POWER indicator (green)
Lights when the POWER switch on the front panel is
turned on.
8 FAILURE indicator (red)
Lights when the circuits inside the unit are not
functioning correctly. Should this lamp light, turn off the
MAIN circuit breaker and consult a Sony representative.
9 ROTATION CONTROL
Adjusts the picture rotation. Use a screwdriver etc. to
turn the control.
0 AC IN socket
Connect an AC power cord here.
Note
When connection to
1 , 5 and 6 , use a double-shielded coaxial
cable.
POWER indicator
VD input connector
HD input connector
I/F connector
MAIN circuit breaker
LANDING SENSOR
connector
R/G/B VIDEO IN
connectors
Rotate the picture
clockwise Rotate the picture
counterclockwise