Sanyo CE32LM4WPR-E - Manual (Page 4)

4
■ REMOVE TERMINAL COVER AS INDICATED BELOW.
■ CONNECT THE DISPLAY UNIT TO AERIAL, VGA. BNC.AND
SCART CONNECTOR AS BELOW.
■ TERMINAL COVER MUST BE REPLACED WITH CABLE EXITS AS
INDICATED IN THE SKETCH ABOVE.
■ Connect the LCD monitor to Aerial, VGA, and Scart connector as
required.
1. Connect the waterproof in-line power connector to the connector
attached to the LCD monitor as shown above.
2. Connect the correct power cord of the LCD monitor to a wall outlet.
✐
As this product does not have a mains On/Off switch, please
ensure your mains plug is easily accessible.
✐
The LCD monitor is prepared for a mains voltage AC220~240V,
50Hz. To completely switch off the mains, or when the LCD moni-
tor is not to be used for an extended period of time, it is advisable
to disconnect the power cord from the power outlet or disconnect
the mains coupler..
3.
Warning: To prevent injury, the unit must be securely attached to
the wall in accordance with the installation instructions.
1.
■
HDMI (High Definition Multimedia Interface)
This monitor has an HDMI connector. When connected to the HDMI
source and HDMI is selected using the remote control,There is a short
time period before the picture appears at a much higher resolution.
This connection is located at the back of the monitor next to the aerial
socket.
2. Y,Pb,Pr connection (AV2)
This LCD monitor has a choice of Y, Pb, Pr or RGB , H/V connections
You can connect your DVD player to the Y, Pb, Pr terminals instead
of using a scart lead. This can support high definition in analogue
component form. RGB, H/V can be used as a PC input via the BNC
terminal.
3. PC connection
This LCD monitor has a PC connector.You can connect a PC to the
LCD monitor and use it as a monitor display (see page 9).
To switch between TV, AV1, RGB, AV2 RGB H/V or Y, Pb, Pr, AV3,
HDMI or PC mode press the TV/ AV switch on your remote control
repeatedly or press and hold the TV/AV button for a few seconds and
a selection menu will appear on screen. Use the
e or d buttons to
select the correct mode.
4. RS232C IN/OUT: Is a input for external commands to control the
monitor (see page 9)
Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the
batteries match the "+" and "-" marks inside the unit into the remote
control handset.
INST INST ALLA ALLA TION TION
Step : 1 Connections (Essential)
AC Mains Outlet
WARNING! High voltages are used in the operation of
this set. Refer service to qualified service personnel.
Security fixing point
Cable entry
Step : 2 Remote control battery installation
HDMI Coaxial aerial IN
Audio monitor
Out
AV2 audio
IN
Serial ports
IN/ Out
Services
AV3 IN/Out
BNC
AV2 IN/ Out
BNC
Waterproof in-line connector
Wall
mount
fixing
positions
Security fixing point
WARNING!
This remote
control is
not
waterproof
Serial
Port-IN
Serial
Port-OUT
Service
GB GB