Snapper 1691827 - Manual

Section A. General
This kit provides an add-on light and required
a l t e r n a t o r f o r c o m p a c t a n d l a r g e f r a m e
snowthrowers with Tecumseh engines. Kit can be
installed on snowthrowers that are equipped with
cabs (hard or soft). See the appropriate section for
installation instructions:
Section Snowthrower Application
Section C. C o m p a c t No Cab/Soft Cab
Section D. Large-Frame No Cab/Soft Cab
Section E. Large-Frame Hard Cab
Section B. Kit Parts
DESCRIPTION
Alternator
B. Screw, l-114” 1704652
Self-Tapping Screw, 1704663
C. AC Ughtlng Connector 1704647
D. Spacer’ 1704646
E. Tube 1704649
F. Alternator Shaft, 3”” 1704641
Alternator Shafl, 1704642
G. Assy. 1704644
H. Plastic 925094
930222
HP Models “7, 6, 10 HP Models
QTY.
1
3
3
1
1
1
1
1
1
2
1
Figure 1.
INSTALLATION
INSTRUCTIONS
SNOWTHROWER HEADLIGHT KIT
MFG. NO. 1691827
Section C. Compact Snowthrower With Cab/
Without Cab.
1. Drill a hole, from bottom and
centered (approx. from either end) on the
crossmember as shown in figure 2.
AD-815
2. Install light with capsorew, lockwasher, and nut
(lockwasher and nut towards rear).
3. Install alternator as provided in the Tecumseh
Installation Instructions. Use the appropriate
alternator shaft (F, figure 1) and self-tapping
screws (B).
4. Install clip and plastic ties as shown in figure 3.
This will prevent wire harness from interfering
with recoil starter.
CLIP I I
F O R M
I N U . S . A .