Southwestern Bell 2-9193 - Manual (Page 6)

6
S
ETTING
U
P
Y
OUR
U
NIT
F
ACTORY
P
RESETS
The following table shows you the factory settings for your unit:
Display Setting
Language English
LCD Contrast 1
Area Code no setting
LDS Code 1
After the adapter is connected, the display will show as indicated below
for setting.
1. “ SET LANGUAGE ” appears on the display. Press the REVIEW UP ( )
button to select the language, E - English, F - French, S - Spanish, and
then press the DIAL button to confirm the selection.
12:00 1/01
E
AM
SET LANGUAGE
2. When “ LCD CONTRAST ” appears, press REVIEW UP ( ) to set the
contrast darker, and then you can press REVIEW DOWN ( ) to set the
contrast back to the preset. The preset value is “1” and “2” is darker.
When you are finished with this setting, press DIAL. The display will
indicate as shown below and is ready to let you set the area code.
12:00 1/01
2
AM
LCD CONTRAST