Samsung DC68-01518Q - Manual (Page 10)

9
HOW TO CLEAN THE FILTER
1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise
and pull out the filter.
3. Remove dirts and rotate
the filter clockwise
until it locks in position.
(pump drained washer)
1.Place a rag under washer filter not to wet the floor.
2.Turn the filter-cap to the left.
3.Take the filter out and
remove dirts.
4. Reassemble in
reverse order.
• When a proper amount (one time does) of fabric
softener is stored in the softener inlet,it is
automatically put in at the last rinsing cycle.
• Do not use detergent, bleach or starch into
the Softener Inlet.
• Using too much softener may produce
unsatisfactory results.
• Do not open the lid during the Spin Dry cycle.
If added too early, its effectiveness will decrease.
• Do not leave the softener
into the Softener
Dispenser for a long time.
Because softner
became stiff.
CLEANING THE FILTER NET Clean the filter net often to keep the washer clean.
1. Push the upper part
of the filter and pull in.
2. Open the cover as
shown in the figure.
3. Clean the filter. 4. Close the cover and insert the
lower part of the filter in the
basket first and then push the
filter with "click" sound .
1. Push up and
pull out the filter net.
2. Remove the collected
lint from the filter net.
3. Clean the filter. 4. Pull down the filter net.
1.Open the detergent box by pulling in the direction of the arrow as shown in the
figure and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent may not brim over the box.
HOW TO PUT THE DETERGENT IN AND ADD THE FABRIC SOFTENER
Detergent Device
Put the detergent
in proportion to
water level
CAUTION : If softener is stored over the above base line, it may flow down at any time.
Softener Device
Softener
baseline
Softener Device
gb-ar-8kg-01518Q 6/5/02 1:22 PM Page 10