Sanyo CDP-M303 - Manual (Page 9)

TRACK-SELECTING PLAYBACK
Press FORWARD SKIP/SEARCH (or
BACKWARD SKIP/SEARCH) to select the
track you wish to play (refer to CD
instructions for additional information.)
Press and hold ALBUM/10+,
appears in the display.
Press
the SKIP/SEARCH to select
.
Press the ALBUM/10+ again and the
first track of the selected
.
Press SKIP/SEARCH to select the exact
track of your choice, and then press
PLAY/PAUSE
NOTE: Example to follow, selection of track
2 of catalog 9:
During playback, press CD ALBUM/10+ to
jump
in increments of 10 within the
current catalog. Then use the forward and
backward
skip/search to refine your
selection.
To select a track in a different catalog, first
select the catalog of your choice, and then
the track, as follows:
catalog
catalog
catalog
appears
К
Л
М
Н
К The first track is in catalog 1 after
pressing PLAY/PAUSE, and the display
shows as follows:
Ë Press and hold ALBUM/10+, the
display will shows catalog " " .
Í Press ALBUM/10+ again, and the 1
track in catalog 9 will flash:
st
Î Press SKIP/SEARCH to select track 2,
and then press PLAY/PAUSE to start
playing.
Ì Press SKIP/SEARCH ( or ) to
select catalog 9, and the display
shows :
16 15
MP3
PROG MP3
PROG MP3
PROG MP3
PROG MP3
PROG MP3
PROG MP3
ELECTRONIC EQ SETTING
In PLAY mode, press EQ/PROGRAM repeatedly to select one of DBB (Deep Bass
Beat), POP, CLASSIC, JAZ, ROCK or NORMAL.
PROGRAM PLAY (upto 64 tracks can be edited)
NOTE: This can only be done in STOP
mode. After pressing STOP, the display
will remain active for ____ seconds.
1. In STOP mode, press EQ/PROGRAM.
2. Press SKIP/SEARCH to select desired
catalog.
3. Press EQ/PROGRAM again.
4. Press SKIP/SEARCH to select the desired
tracks.
5. Repeat the above steps to program the
other tracks.
6. Press PLAY/PAUSE to enter program play.
As an example, to select track 3 in catalog 5:
1. In STOP mode, the display shows
" " .
2. Press EQ/PROGRAM. The display shows
" " and the catalog " "
flashes.
3. Press SKIP/SEARCH to select catalog 5.
The display shows" " .
4. Press EQ/PROGRAM, and the track
number " " flashes.
5. Press SKIP/SEARCH to select track 3, and
" " appears.
6. Press EQ/PROGRAM again; " "
appears, ready to select the second track.
MP3
7. Repeat the above steps to select the
desired tracks.
8. When programming is complete, press
PLAY/PAUSE to begin program playing
mode.