Source Technologies STM.117B - Manual (Page 12)

20 21
Line Print Mode Compatibility
SETLP ○
SETLF ○
Moving With X and Y Coordinates ○
LMARGIN ○
SETBOLD ○
SETSP ○
Special ASCII Characters ○
SETFF ○
SET-TOF ○
SETLP-TIMEOUT ○
FCC Information
This device complies with part 15 of the FCC Results. Operation is
subject to the following two conditions:
(1) This Device may not cause harmful interface, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for CLASS
B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance
with the instuctions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try correct the interference by one or more of the
following measures:
1.1. Reorient or relocate the receiving antenna.
1.2. Increase the separation between the equipment and receiver.
1.3. Connect the equipment into an outlet on a circuit different from
that to which receiver is connected.
1.4. Consult the dealer or experienced radio/TV technician for help.
WARNING
Changes or modifications not expressly approved by the manufacturer could void
the user's authority to operate the equipment.
8.Certification
NOTE