Sharp R-1600 User Manual

Page 26

Advertising
background image

24

CHARCOAL FILTER

Charcoal Filter, Sharp Part number RK-230 which was
enclosed with your oven, is used for nonvented, recir-
culated installation. The filter should be changed every
6 to 12 months depending on use. See page 4 for or-
dering information.

1. Disconnect power to the oven at the circuit breaker

panel or by unplugging.

2. Remove the louver mounting screw from the top

center of the louver and push down carefully on the
tab at each end of the louver to disengage it. (See
illustration.)

3. Pull the louver away from the unit.

4. Change the charcoal filter.

5. Carefully push the louver back into place (engaging

both the bottom and top tabs) and replace the screw
removed in step 2.

OVEN LIGHT

Remove the louver per instructions 1-3 above and
charcoal filter, if used.

1. To replace light bulb, first disconnect power to the

oven at the circuit breaker panel or by unplugging.

Light cover

Screw

Light bulbs

R E P L A C I N G P A R T S

WORK LIGHT AND NIGHT LIGHT

1. To replace light bulbs, first disconnect power to the

oven at the circuit breaker panel or by unplugging.

2. To release cover, remove the screw on the light cover.

(See illustration.)

3. Replace light bulbs with equivalent watt bulb

available from your Sharp Authorized Servicer or
parts distributor. Bulbs are also available at most
hardware stores or lighting centers. DO NOT USE
A BULB LARGER THAN 30 WATTS.

4. Close light cover and secure with screw removed in

step 2.

CAUTION: Light cover may become very hot. Do not

touch glass when light is on.

2. Open light cover located behind filter mounting by

carefully pulling up on the front edge.

3. Remove old light bulb and replace only with equiva-

lent watt bulb available from a Sharp Authorized
Servicer or parts distributor. Bulbs are also avail-
able at most hardware stores or lighting centers.
DO NOT USE BULB LARGER THAN 30 WATTS.

4. Replace the oven light cover by carefully pushing

into place. Replace the charcoal filter, if used. Push
the louver back into place and replace the louver
mounting screw.

Oven light

Hood louver

Charcoal filter

Screw

Advertising
This manual is related to the following products: