Solid State Logic MX4 - Manual (Page 22)

Firmware Updates
Updated MX4 firmware will be available for download from our website whenever necessary.
Typically, any new firmware will be included as part of a new driver package.
Please locate the TRack.exe Applet inside the latest Driver Installation folder. TRack does not need to be installed and can just
be opened with a double-click. You can also copy the Applet to your Desktop or any other location.
• When the TRack software is launched, the Firmware
Updater starts up automatically if a MX4 with obsolete
firmware is detected. In such cases, click Next to proceed.
• Please close any streaming applications currently
running, and wait while the firmware is updated. After the
update, click Finish and then power-down, wait 20
seconds and then re-start the computer. (cold start)
It is extremely important that the power supplied to the computers PCIe Bus is disconnected for a short period after the
firmware has been updated. The MX4 only loads the new firmware image into the hardware on a new power-on reset
command. If the card receives constant power from the PC mainboard, or if the PC is switched off for a too short period of time,
the new image will not be loaded permanently into the MX4…
Page 22