Sunbeam EM3800 - Manual (Page 25)

23
10. Leave the machine off for 10-15 minutes
to allow the descaler solution to take
affect.
11. Press the power switch to turn the
espresso machine on.
12. Turn the operating dial to the espresso
setting and allow the remaining solution
to cycle through the group head.
13. Remove the water reservoir from the
machine and rinse thoroughly under
running water, ensuring that all traces
of the descaling solution is removed.
Fill with clean water and replace the
reservoir.
14. Turn the operating dial to the espresso
setting and allow the entire water
reservoir to cycle through the group head.
Note: Depending on the size of the container
under the group head on occasion this may
need to be emptied throughout this process.
15. When this is finished remove the
container under the group head and give
the machine a good wipe over.
16. Carefully replace the rubber seal, brewing
filter/shower screen and washer to the
group head. Tighten well.
17. Fill the water reservoir with fresh water
and position it on to the machine.
Descaling (continued)