Salton, Inc KM-1078 - Manual (Page 4)

HOW TO ASSEMBLE / DISASSEMBLE
IMPORTANT: Before inserting and removing accessories or raising or lowering
the Mixer Head, switch off the mixer and remove the plug from the electrical
outlet.
Assembling the Bowl
To install the Bowl place the bottom of the Bowl on the turntable in the Base.
Turn the Bowl clockwise until it locks into position.
Disassembling the Bowl
To remove the Bowl, turn counter-clockwise and lift away from the Base.
Assembling the Whisk, Flat Paddle Beater, and Dough Hook
Align the Accessory Head of the Whisk, Flat Paddle Beater or Dough Hook with
Hooking Pin on Accessory Shaft on the underside of the Mixer Head. Push the
accessory as far as it will go into the Accessory Shaft and turn counter-clock-
wise, hooking Whisk, Flat Paddle Beater or Dough Hook over pin.
Disassembling the Whisk, Flat Paddle Beater, and Dough Hook
To remove the Whisk, Flat Paddle Beater or Dough Hook push up and twist
clockwise to release from Hooking Pin on Accessory Shaft.
NOTE: The Bowl and Accessories can only be removed when the Mixer Head is
raised.
Adding or Removing the Splash Guard
Before attaching the Whisk, Flat Paddle Beater or Dough Hook, raise the Mixer
Head and place the Splash Guard onto the rim of the Stainless Steel Bowl and
turn the opening of the Pouring Spout to the desired position.
NOTE: You do not need to remove the Splash Guard to change tools.
To remove the Splash Guard, raise the Mixer Head and lift Splash Guard away
from the Stainless Steel Bowl.
Raising or Lowering the Mixer Head
Push the Mixer Head Lock/Unlock Lever. The Mixer Head will rise and lock into
place automatically.
To lower the Mixer Head, push the Lock/Unlock Lever and gently push
down on the top of the Mixer Head until it locks into place.
4
Booklet_KM-1078_ENG 7/3/08 2:44 PM Page 4