SWR Sound Workingman's Series Bass Speaker 1X10T - Manual (Page 8)

WORKINGMAN’S 2X10T
Specifications Specifications
Description: 2x10 and Tweeter Speaker Enclosure
Power Handling: 200 watts RMS
Impedance: 8 ohms
Frequency Response & SPL:
98 dB SPL @ 1W1M (–3db @ 63 Hz and 18.5 KHz)
Speaker Complement:
(2) Custom Designed 10" SWR Drivers
(1) Custom Designed Tweeter
Porting: Front Slot Port
Dimensions: 23"W x 17"H x 16.25"D
Weight: 60 lbs.
Connection and Operation
The SWR WorkingMan’s 2X10T speaker enclosure can be connected to any musical instrument
amplifier that is capable of driving an 8 ohm load. To connect your amplifier to the Workingman’s
2X10T, run a high quality speaker cable (18 gauge or heavier) from your amplifier's speaker output
to the designated 1/4" speaker input on the cabinet’s input panel.
Power Handling
The power output rating for any amplifier that is connected to the WorkingMan’s 2X10T should not
exceed the cabinet’s 200 watt power handling capacity. Please be aware that exceeding the power
handling capacity of the WorkingMan’s 2X10T can void the SWR warranty if any damage occurs to
your loudspeakers due to overpowering.
Tweeter Control Switch
(See page 3.)
Internal Crossover
The internal (passive) crossover of the WorkingMan’s 2X10T divides the incoming signal into two
frequency bands. The crossover point is 5kHz (frequencies above 5kHz are sent to the tweeter,
frequencies below 5 kHz are sent to the 10" speakers).
7