Sharp PG-A20X - Manual (Page 48)

-44
You can use the “Options” menu to enhance the usage for the projector. For operation of the
menu screen, see pages
32 to 35 .
Example: “Options” menu screen for
INPUT 2 (S-Video) mode
Lamp Timer (Life)
(Check-
ing the Lamp Life Status)
You can confirm the cumulative lamp usage time
and the remaining lamp life (percentage).
Display the “Options” menu to check the
lamp life status.
Description of Lamp Life
Note
• It is recommended that the lamp be changed
when the remaining lamp life becomes 5%.
For lamp replacement, contact your nearest
Sharp Authorized Projector Dealer or Service
Center.
• The table above indicates rough estimates in the
case of using only in each mode shown. Remain-
ing lamp life changes within the range of the val-
ues shown depending on the frequency at which
“Eco Mode” is switched to “
” (Eco mode) and
“ ” (Standard mode) (see page 45 ).
Using the “Options” Menu
Remaining lamp life
100% 5%
about
4,500 hours 225 hours
about
3,000 hours 150 hours
Lamp usage condition
Used with only “ ”
(Eco mode) in “Eco
Mode”
Used with only “
”
(Standard mode) in
“Eco Mode”
Keystone
(Setting the Key-
stone Correction Mode)
Select “Keystone” on the “Options” menu
and the desired mode for the Keystone
Correction.
Description of Keystone Correction Mode
Note
• If you want to adjust the Keystone Correction
manually, see page 29 .
• The Keystone Correction can be adjusted up to
an angle of approximately ±12˚ when the Key-
stone Correction mode is set to “Auto”, or ap-
proximately ±35˚ when set to “manual” (when the
picture display mode is set to “NORMAL” (see
page
40 )).
Selectable settings
Auto
Manual
Description
Keystone Correction is automatically
performed.
Keystone Correction can be adjusted
manually.
Auto
Manual
PG-A20X_E_PDF_P40_50.p65 03.4.23, 9:58 AM 44