Sonic Alert SBS550BC - Manual (Page 3)

INSTRUCTIONS
The Skull ALARM CLOCK WITH Bone Crusher
MODEL SBS550BC
Please retain the instruction manual for future reference.
Features show on diagram above:
1.
Alarm Indicator
2. PM Indicator
3. Alarm Function Switch
4. Dimmer Switch
5. Skull Snooze button
6. Skull LED Light
7. Volume Knob
8. Flashing Light Display
9. Tone Control Knob
10. Alarm Set
11. Hour Button
12. Minute Button
13. Time Set Button
14. Alarm Off Button
15. Bone Crusher Output
16. AUX Line-in Jack
17. AC Adaptor
18. Battery Compartment
19. Hour Format & Power
Cycle
INSTALLATION
AC 9V Power Input
Attach the AC power supply input to the side of clock at AC9V IN (17) next to the VIBRATOR input (15),
smaller input of the two. Important: do not confuse AC input with vibrator input. The eyes of the skull will
light up continuously when it is connected to the power source.
Bone Crusher / Vibrator – Figure B
1) Attach the bed shaker jack to the back of the clock at VIBRATOR input (15).
2) Place Bone Crusher under mattress (best) or pillow.
Battery Backup
To use the battery backup, you can install a 9-volt alkaline battery in the back of the clock located under the
battery cover (18). Note the LED display will not light up during power failure but the clock will still be
running and keeping proper time until the power is restored.
NOTE: For the best results it is recommended that the battery be changed every 6-8 months. If the clock is
not used for a while, it is recommended to remove the battery to aviod leakage.
OPERATION
Setting the correct time
1) Press and hold the Time Button (13) at the same time press the Hour Button (11) to advance the
clock display rapidly until the hour is correct; press the Minute Button (12) to advance the clock
display rapidly until the hour is correct.
2) A lighted dot (2) in the upper left of the clock display indicated the time is PM. For AM time
indication, the dot (2) does not light up.
Setting the alarm time
1) Simply follow the instructions mentioned under “Setting the correct time“ except that you will have
to press the Alarm Set Button (10) instead of the TIME Button.