Soundstream Technologies SPL 45 - Manual (Page 5)

5
INSTALLING
THE SPL 45
The SPL 45 can be mounted on the front or rear of
a panel; gaskets are provided for both options. The
bolt hole configuration will fit a variety of American,
European and Asian OEM patterns making it ideal
for direct placement. Best performance is achieved
when the speaker is securely mounted to a door
panel or rear deck. There should be no gaps
between the speaker and the mounting surface, as
this will impair its low frequency performance. Be
certain that both the panel and the speaker are
securely mounted to prevent unwanted vibration.
1) Mark the speaker location by using the
template provided.
2) Cut the opening and debur the edges with a
file.
3) Hold the speaker in place against the mounting
surface and mark the mounting bolt holes.
6) Drill the appropriate size hole for the screws
provided.
7) Place the SPL 45 into the trim ring, make the
speaker wire connections, then install the
speaker/trim ring assembly to the panel using
45.pub
page 5 Friday, September 10, 1999 21:04