Samsung DynaFlat TX R2765 - Manual (Page 26)

O P E R AT I O N
26
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna)
and cable channels. After the available channels are memorized, use the CH and
CH buttons to scan through the channels. This eliminates the need to change chan-
nels by entering the channel digits. There are three steps for memorizing channels:
selecting a broadcast source, memorizing the channels (automatic) and adding and delet-
ing channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press the MENU button to
display the menu.
Press the ▲ or ▼ button to
select “Channel”, then press the
ENTER button
2
Press the ▲ or ▼ button to
select “Air/CATV”.
Note: STD, HRC and IRC identify various types of cable
TV systems. Contact your local cable company to identify
the type of cable system that exists in your particular area.
At this point the signal source has been selected. Proceed
to “Storing Channels in Memory” (next page).
3
Repeatedly press the ˇ or ˆ
button to cycle through these
choices: “Air” (antenna) “STD”,
“HRC” or “IRC” (all cable TV).
Press the EXIT button to exit the
menu.
Move Enter Return
Channel
Auto program ˆˆ
Add/Delete ˆˆ
Fine tune : 00
Air/CATV : Air
Name : - - - -
Move Adjust Return
Channel
Auto program ˆˆ
Add/Delete ˆˆ
Fine tune : 00
Air/CATV ˇˇ Air ˆˆ
Name : - - - -
Move Adjust Return
Channel
Auto program ˆˆ
Add/Delete ˆˆ
Fine tune : 00
Air/CATV ˇˇ Air ˆˆ
Name : - - - -