Samsung MAX-B450 - Manual (Page 9)

GB
9
Insert or replace remote control batteries when you:
Purchase the mini-compact system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and
never mix alkaline and manganese batteries.
Place your thumb on the position marked on the battery com-
partment cover (rear of the remote control) and push the cover in
the direction of the arrow.
Insert two AAA, LR03 or equivalent batteries, taking care to respect
the polarities:
+ on the battery against + on the remote control
– on the battery against - on the remote control
Replace the cover by sliding it back until it clicks into position.
You can view the various functions available on your system
and you can also dim out for the window displayer.
Press the Demo/Dimmer button.
Result: The various functions available are listed in turn on the
display.
All these functions are described in detail in this booklet.
For instructions on how to use them, refer to the appropriate
sections.
Press Demo/Dimmer again.
Result: The window displayer become dim out .
The window displayer can be used more longer at the dimmer
state.
Power turn on state ONLY:
Press Demo/Dimmer again.
Result: The window displayer become normal display .
Your system is equipped with a clock which allows you to
turn your system on and off automatically. You should set the
clock:
When you purchase the mini-compact system
After a power failure
After unplugging the unit
Remember to reset the time when the clock changes from
winter to summer time and vice verse.
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing Standby/on.
Press Timer/Clock twice.
Result:
CLOCK is displayed.
Press Enter.
Result: The hour flashes.
To... Press the...
Increase the hours Tuning Up
Decrease the hours Tuning Down
When the correct hour is displayed, press Enter.
Result: The minutes flash.
To... Press the...
Increase the minutes Tuning Up
Decrease the minutes Tuning Down
When the correct time is displayed, press Enter.
Result: The clock starts and is displayed, even when the system is
in standby mode.
You can display the time, even when you are using another
function, by pressing Timer/Clock once.
You can also use Program/Set button on the remote control
to instead Enter button in step 3,5,7.
Setting the Clock
Viewing the Various Functions on
Your System and Dim Out for Display
2
1
1
2
3
4
5
6
7
Inserting Remote Control Batteries
1
2
3
1
4,6
3
3,5,7
2
4,6
MAX-B420/B450GB no rds-1~14 1 5/16/02 11:11 PM Page 9