Summit 21287 - Manual (Page 9)

9
4) Screw the regulator coupling onto the tank valve, clock-
wise, or to the right. Hand-tighten only.
Note: This connection tightens clockwise and will not allow
gas to fl ow unless the connection is tight. The connection
requires tightening by hand only.
ƽ WARNING: Do not use a wrench to tighten the con-
nection. Using a wrench could damage the regulator
coupling and could cause a leak.
5) Mix soap and water.
6) Turn on the cylinder valve.
GAS INSTRUCTIONS
To Connect the hose to the cylinder:
3) Remove the plastic dust cover from the valve.
Some of the tanks have differing top collar assembles. (The
top collar is the metal protective ring around the valve.) One
series of tanks mount with the valve facing front. The other
tanks mount with the valve facing away from the fuel scale.
These types of tanks are illustrated below.
You will need: LP cylinder, a soap and water solution and a
rag or brush to apply it.
1) Turn the LP cylinder so the opening of the valve is either
to the front, side or rear of the Weber ® gas barbecue. Lift
and hook the cylinder onto the fuel gauge.
2) Loosen the cylinder lock wing nut. Swing the cylinder
lock down. Tighten the wing nut.
CONNECTING THE LIQUID PROPANE CYLINDER
ƽ WARNING: Make sure that the LP cylinder valve is
closed. Close by turning valve clockwise.
ƽ DANGER
Do not use an open fl ame to check for gas
leaks. Be sure there are no sparks or open
fl ames in the area while you check for leaks.
Sparks or fl ames will result in a fi re or explo-
sion which can cause serious bodily injury or
death, and damage to property.
7) Check for leaks by wetting the fi tting with the soap and
water solution and watching for bubbles. If bubbles form,
or if a bubble grows, there is a leak.
If there is a leak, turn off the gas and tighten the fi tting. Turn
the gas back on and recheck with the soap and water solu-
tion.
If leak does not stop, Contact the Customer Service Repre-
sentative in your region using the contact information sheet
provided with your manual. Do not use the barbecue.
8) When leak checking is complete, turn gas supply OFF at
the source and rinse connections with water.