Silvercrest KH2376 - Manual (Page 13)

15
Installation
Bluetooth Car Radio KH 2376
GB
To connect the device to two speakers use only the cables for the front speakers.
NOTICE
Make sure that a permanent positive connection is applied to the station ►
memory of connection 4 in the ISO block A.
In some automobile models the standard confi guration of the connections
►
[4] and [7] in ISO block A are interchanged at the factory. If this is the
case the station memory can be lost. To correct this, the connections 7
(Ignition positive) and 4 (Permanent positive) in the ISO Block A must be
swapped.
You can connect an external amplifi er to the audio cinch output. For this
►
follow the operating instructions for the external amplifi er.
Antenna power connection
IMPORTANT
Possible damage to the device!
Never attach the antenna power connection with the antenna's motor ►
power cable.
The connection for the antenna power is available for a relay controlled antenna.
The relay then automatically extends the antenna when the device is switched
on. When switched off the antenna retracts. This connection can also be used to
control an external amplifi er. For exact connection information please consult the
amplifi er's operating instructions.
Connection of an external amplifi er
For the connection of an external amplifi er use the audio cinch output LINE
OUT
39 . For this follow the operating instructions for the external amplifi er.
Connecting the microphone unit
For connection of the microphone unit use the microphone unit socket 37 .