Star Micronics LC-6211 - Manual (Page 26)

20
Chapter 3: Using the EDS Mode
The letters “EDS” stand for “Electronic DIP Switches.” Just like the small DIP
switches that are used by many computers, printers, and other devices, the EDS
lets you configure the printer so that it matches your system and software needs.
This chapter describes how to enter the printer’s EDS Mode and provides details
about available settings and how to change them.
The following table shows the three categories of EDS settings that are
available, along with the actual settings under each category.
All switch settings are ON when the printer is shipped from the factory.
Category Setting On Off
General RAM Usage Input Buffer Download Buffer
Graphics Direction Bi-directional Uni-directional
Tear Off Disabled Enabled
Auto LF With CR Disabled Enabled
Paper Out Enabled Disabled
Line Spacing 1/6-inch 1/8-inch
STROBE Timing Normal Reverse
Font Print Mode Draft NLQ
Banking Character Disabled Enabled
Zero Style Normal Slashed
Character Table Graphics Italic
Page Length 11
″
/Letter (default setting)
8”
11.7
″
/A4
12
″
8.5
″
/letter
14
″
/Legal
10.5
″
/Executive
7.25
″
/Executive
3.5
″
5.5
″