Smeg PLTW640X - Manual (Page 30)

User instructions
31
FAULT DESCRIPTION
E8
Alternate washing system malfunction
Interrupt the program and switch off the
dishwasher. Switch the dishwasher back on,
program it again and start the washing cycle. If
the problem persists, contact the after-sales
service.
E9
Water intake system malfunction
Contact the after-sales service.
Light off Light on Light flashing
If an alarm occurs the appliance interrupts the program in progress and
signals a fault.
• Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program
immediately.
• The E5, E6 alarms interrupts the running program once the cause is
resolved, it will bring bach the execution of the program.
• The alarm E7 is visualized at the end of the cycle that comes, however,
brought to the end since the operation of the dishwasher is not harmed.
To “reset” an alarm is necessary:
• Open and close the door, or turn off and on the machine. At this point is
possible to program the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.
TECHNICAL DATA
Width 597 ÷ 599 mm
Depth measured flush with the
outer edge of the control panel Free standing: 600 mm
Semi-integrated: 570 mm
Height
Free standing from 850 mm to 870 mm
Semi-integrated from 820 mm to 870 mm
Capacity 12 Standard place settings
Water supply pressure min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar)
Electrical characteristics See rating plate
Bio
Bio