Samsung DVD-R155 - Manual (Page 15)

C
onnecting & Setting Up
English - 15
Step 1 : Connecting HDMI/DVI to a TV
If your TV has a HDMI/DVI input, connect an HDMI/DVI cable to your TV. You will enjoy the best quality image
and sound.
Connecting to a TV with an HDMI Jack
Using an HDMI- HDMI cable (not included) connect the HDMI OUT jack on the rear of the DVD Recorder to the
HDMI IN jack of your TV. Press the input selector on your TV remote control until the HDMI signal from the DVD
Recorder appears on your TV screen.
▌
To watch through the HDMI output, set the digital
audio output to PCM.(See page 30)
Depending on the HDMI device(TV/HDMI
Receiver) you use, audio may not be supported.
If your TV does not support Dolby digital/DTS,
Audio output is not available when you set the
Digital output to Bitstream or select DTS On in
the Audio setup menu. In this case, set the digital
audio output to PCM or DTS Off.
If you use an HDMI cable to connect a Samsung
TV to the DVD recorder, you can operate the
recorder using the TV's remote control. (This is
only available with SAMSUNG TVs that support
Anynet+(HDMI-CEC).) (See page 28) ■
■
■
Please check the logo (If your TV has an
logo, then it supports Anynet+ function.)
■
Connecting & Setting Up
01317A-01-R155-XAA-ENG.indb 15 01317A-01-R155-XAA-ENG.indb 15 2007-01-25 오후 4:32:50 2007-01-25 오후 4:32:50