Sunrise Medical Quickie S-646 User Manual
Page 7
930576 Rev. A
V I . O p e r a t i n g G u i d e
13
V . S e t - u p , A d j u s t m e n t & U s e
930576 Rev. A
12
A. TOGGLE SWITCH ACTIVATION
1. To operate, pull the toggle switch (A) back
toward rider (to tilt back) or push toggle for-
ward away from rider (to return to neutral) until
tilted into the desired position.
2. The toggle switch will return to neutral when
released and the seating system will stop mov-
ing.
B. SINGLE SWITCH ACTIVATION
1. Depress and hold single switch to tilt back into
the desired position.
2. Depress and hold single switch to return to
neutral until tilted into the desired position.
C. REMOTE JOYSTICK ACTIVATION (OPTIONAL)
From the “off” position
1. Push the on/off mode select toggle switch (A)
down once to turn the chair “on”.
2. Push the on/off mode select toggle switch (A)
up twice to move index to tilt mode (noted by
two (2) actuator lights (B).
3. Push the joystick (C) either forward or backward
until tilted into the desired position.
4. Push the on/off mode select toggle switch (A)
up once to return to drive mode.
D. SPECIALTY DRIVE CONTROLS
Please refer to your QTRONIX USCM User Instruction
Manual
CAUTION– The tilt lock-out feature will activate and
the chair will not tilt on slopes steeper
than 6 degrees.
CAUTION– The power base drive lock-out feature will
activate and the chair cannot be driven if
the seating system is tilted more than 15°.
A
B
C
A
H. TM40 SINGLE OR DUAL SWITCH ACTUATOR CONTROLLER
The TM40 actuator controller can be used to activate the tilt mechanism with either
single or dual switch controls.
1. Plug limit switch harness assembly (A) into TM40 limit switch jack (B).
2. Plug single switch (C) into TM40 single switch jack (D) OR plug dual switch (E)
into TM40 dual switch jack (F).
3. Plug TM40 into the QTRONIX Power Module (G).
4. Use mating plugs (H) to connect the TM40 to the tilt actuator.
I. CHECK-OUT
Once the tilt assembly is adjusted, it should actuate smoothly and easily.
All accessories should also perform smoothly.
1. Verify seat can achieve full tilt and will return to neutral.
2. Verify that the seat frame stops engage the stop pin cushions.
3. Verify the motor cuts out once the neutral position is reached.
4. Verify no debris is interfering with the glide bearings.
5. Verify all hardware is securely tightened.
QTRONIX Power Module
E
A
B
D
F
H
G
Stereo Jack