Sony DPP-M55 - Manual (Page 6)

6
(GB)
Inserting the print paper
Notes
• Do not touch the printing surface (the side where nothing is
printed).
• Do not place the print paper in a dusty location. Fingerprints
or dust on the printing surface may result in imperfect
printing.
• Use the print paper recommended for this printer only. If you
use a different type of paper, it may cause problems and the
printer may not print properly.
• To prevent paper from jamming, do not insert another sheet
of print paper before you take out the printout.
• Do not hand-write or type an address or other characters or
drawings in the reverse side of the print paper before
printing. This may cause paper jamming, or failure in
printing.
• You cannot type on the printing surface; use an oil ink pen to
write greetings or other characters or drawings on the
printing surface.
You can use the print paper with the VP mark.
Insert the print paper only one sheet at a time.
1
Connect the supplied power cord,
and turn on the power.
2
Send the print command from the
computer or Sony digital still
camera.
First the data transmission indicator starts
flashing and then the print paper indicator starts
flashing.
3
Insert a sheet of print paper into
the paper inlet until less than 2 cm
(13/16 inches) of the print paper is
left out of the paper inlet.
The print paper automatically loaded into the
printer.
Power switch Power cord
(supplied)
to the wall outlet
Getting Started
Less than 2 cm
(13/16 inches)