Sirius Satellite Radio SIR-SL1 - Manual (Page 26)

Streamer GT SIR-SL1 User Guide
26
Changing the Lock/Unlock Code
The first time the Lock/Unlock function is accessed,
the user must enter the default lock code. The
default lock code is “1111”. This code can be
maintained or changed. To change the lock code,
perform the following procedure while in the “Menu
Options” List mode:
1. Use the Channel Switch to highlight “Lock
Options”. Press SELECT.
2. Select “Edit Code” from the Lock Options Menu
and press SELECT.
3. Enter your current code or the default code “1111”.
4. The “New Code” prompt will appear. Enter your new
four digit code using the 1-6 number buttons. You
will then be prompted to confirm the new code by
entering it again.
5. The lock code is now changed.
Note: You can use this same method to edit the
code after it has changed from the default.
Enter Code
# _ _ _ _
Channel Block
The Streamer GT Receiver has the ability to lockout
the use of any channels you do not want others to
access without your permission. The locked channel
will not appear when the user changes channels with
the Channel Switch. When the user tries to access a
locked channel using the Direct Tuning function, the
“Enter Code” screen will be displayed and the
channel will not be accessed until the proper code is
entered.
While in the “Menu Options” List mode, follow the
steps below to Lock a channel:
1. Use the Channel Switch to highlight the “Channel
Block”. Press SELECT.
2. Select “Lock/Unlock” from the Lock Options Menu
(below left) and press SELECT.
3. Use the Channel Switch to select the channel you
want to lock. Press SELECT (below right).
Channel Block
Lock/Unlock
Edit Code 003 CH Name
001 CH Name
002 CH Name L