Sharp AR-M236 - Manual (Page 71)

69
TROUBLESHOOTING AND MAINTENANCE
5
MISFEED IN THE UPPER EXIT AREA
(when a job separator tray kit or finisher (AR-FN5N) is
installed)
If a job separator tray kit or a finisher is installed, a misfeed may occur in the upper exit area.
1 Open the upper right side cover.
2 Gently pull the misfed paper out.
Be careful not to tear the
misfed paper during
removal.
3 Close the upper right side cover.
Make sure that the misfeed message is cleared.
MISFEED IN AN OUTPUT TRAY
(when a finisher (AR-FN5N) is installed)
1 Grasp the handle of the stapler
compiler cover and pull to open the
cover. 2 Remove any misfed paper from the
transport area.
A MISFEED HAS OCCURRED.
INFORMATION