Standard Horizon Hx 350s - Manual (Page 18)

page 16 Owner’s Manual HX350S
4.17 RESETTING THE TRANSCEIVER’S MICROPROCESSOR
Resetting the microprocessor restores the initial, factory supplied conditions
in the transceiver. These are called the default conditions. To reset the
microprocessor, first turn the transceiver off. Then while holding the WX and
SCAN keys pressed, turn the transceiver on. The default conditions are:
• No channel numbers are in memory.
• Channel 16 is the priority channel.
• Channel 16 will be selected when the transceiver is turned on.
• WX channel 01 will be recalled when the WX key is pressed.
• Channels A and B are unassigned.
• No voice scrambler code is selected.
NOTE
The above procedure also resets the microprocessor. Perform this
procedure if an operational problem occurs.