SECO-LARM USA H.264 Network DVR DR-116Q - Manual (Page 5)

ENFORCER DR-1 Series H.264 Network DVR Quick Setup Guide
SECO-LARM U.S.A., Inc. 5 SECO-LARM U.S.A., Inc.
33 5
Connections:
1. Connect cameras to the BNC channel inputs on the rear of the device.
2. Connect a VGA-capable display to the VGA port on the rear of the device.
3. If connection to a Call Monitor is desired, connect via the BNC port marked Call Monitor Out on
the rear of the device.
4. If network access to the DVR is desired, connect the DVR to a Local Area Network (LAN) using
a Cat5e/6 cable with an RJ-45 connector.
5. If using a mouse to operate the DVR On-Screen Display, connect a standard USB mouse via
the USB port on the front or rear of the device.
6. When all connections have been made, plug the included power adapter into a 110~240 VAC
power outlet. Connect the adapter to the power input on the rear of the device.
Note: To avoid possibility of data loss, never unplug the adapter before properly shutting down
the device. For more information see the section Shutting Down the DVR on page 11.
Getting Started:
Initial System Setup:
1. To enter the system menu, press MENU on the device’s front panel or remote control, or if
using a mouse, right click when viewing the main screen and select the “MENU”.
2. Enter the administrator username and password.
IMPORTANT: FOR SECURITY PURPOSES, CHANGE THE PASSWORD IMMEDIATELY
AFTER ENTERING THE MENU FOR THE FIRST TIME. FAILURE TO DO SO MAY
SERIOUSLY COMPROMISE THE SECURITY OF THE SYSTEM.
Note: Default username: admin Default password: 1234.
Note: Username is case sensitive.
3. To change the system password:
a. Enter the system menu following steps 1 and 2 above.
b. Select SYSTEM using the left/right buttons and press ENTER, or use a mouse to left click
the icon.
c. Select User Management.
d. For the first account, “admin”, select Edit in the column marked PWD. Enter a new 4~8 digit
password. Note: admin account ID cannot be changed. Choose a password that is
memorable but not easily guessed by others.
e. For the second account, “user”, select Edit in the column marked ID. Enter a new name, if
desired. When finished select OK. Next, select Edit in the column marked PWD. Enter a new
4~8 digit password as described in part d. above.
f. By default there are only two user accounts active. If other accounts are added, be sure to
change the password to ensure the security of the system. See the User’s Manual section
3.2.1 User Management for details on how to add and edit user accounts.
System Menu