Sanyo ECD-T1535 - Manual (Page 8)

8
RADIO OPERATION
• BAND SELECTION
At tuner mode, press BND/LOU button (13) to select the desired band.
The reception band will change in the following order:
• STATION SELECTION
Press MANU/SKIP button (16) or MANU/SKIP button (17) to activate
automatic seek function. To select manual tuning mode, press for several seconds
until “MANUAL” appears on the display. If both buttons are not pressed for several
seconds, the tuner will return to seek tuning mode and “AUTO” will appear on the
display.
• LOCAL/DISTANCE
Press LOC button (2) to select between local and distant stations.
Local setting for reception of strong station, and a distant setting for reception of
weaker stations. This function is in effect during AUTO SEEK operation.
• AUTOMATIC MEMORY STORING & PROGRAM SCANNING
- Automatic Memory Storing
Press ATP button (18) for several seconds, the radio will search from the current
station and check the signal strength until one cycle search is finished. The 6
strongest stations detected will be stored into the corresponding preset button.
- Program Scanning
Press ATP button (18) shortly to scan preset station.
• STATION STORING
Press any one of the preset buttons (14) (M1 to M6) to select a station which had
been stored in the memory. Press this button for several seconds to store the
current station into that preset button.
• SEEK FUNCTION
Press SEEK button (1) to scan and hear all tunable stations for a few seconds.
Press SEEK again to stop at current station.
FM1 FM2 FM3 AM