Sony HT-V600DP - Manual (Page 42)

42
Troubleshooting (Continued)
Symptom
Some channels are
skipped over when using
CH/PRESET(+/–).
Picture and sound of
broadcasting channel are
weak or missing.
Camcorder image is not
shown.
Camcorder image via
A/V input to DVD/VCR
Receiver is not shown on
TV screen.
Timer recording is not
possible.
Stereo Audio Record
and/or Playback is not
present.
Cause
Those channels were deleted with the
CH. ADD/DEL option.
Antenna or cables are loose.
Wrong CHANNEL SOURCE option is
being used.
Camcorder is off.
DVD/VCR Receiver INPUT SELECT is
not set to LINE1(L1) or LINE2(L2).
Clock in DVD/VCR Receiver is not set
to correct time.
Timer has been programmed
incorrectly.
TIMER indicator light does not appear
after programming timer.
TV is not Stereo-compatible.
Broadcast program is not in stereo for-
mat.
DVD/VCR Receiver A/V Out jacks are
not connected to TV A/V In jacks.
DVD/VCR Receiver Audio/Video Out is
not selected for viewing at the TV.
DVD/VCR Receiver BROADCAST
TYPE mode is set to SAP or MONO.
Correction
Use CH. ADD/DEL option on the TUN-
ING menu to restore channels. See
“Channel Selection” on page 18.
Tighten connections or replace cable.
Try all CHANNEL SOURCE options.
See “Channel Selection” on page 18 for
details.
Turn camcorder on and operate
properly.
Use INPUT SELECT to select LINE
input channel (LINE1(L1) or LINE2(L2)).
Set clock to correct time. See “Setting
the Clock” on page 19.
Reprogram Timer. See “Timer
Recording” on pages 25 and 26.
Reprogram Timer and turn DVD/VCR
Receiver off to enable timer.
No action is possible.
No action is possible.
Make A/V connections. Stereo is
available only via A/V output from
DVD/VCR Receiver.
Select A/V source as TV input.
Set BROADCAST TYPE mode to
STEREO. See “Using the VIDEO Setup
Menu” on page 18.