Samsung SVD-4300 - Manual (Page 20)

Troubleshooting
COLOR CCD CAMERA User’s Manual 39 COLOR CCD CAMERA User’s Manual 38
Refer to the following table if you are experiencing trouble with your camera.
Contact an authorized technician if the table does not provide you with a
solution to the trouble.
Problem
No display
Dim display
Dark display
The camera is not functioning
properly and its surface is hot
Motion Detection
feature is not active.
Uneven colors
Flickering
Can't select LL mode
LL is not function
properly.
Solution
• Check the power cable and the wiring between the
camera and the monitor.
• Ensure proper video cable connection (Video Out
Jack).
• The lens could be dirty. Clean with a soft, clean
piece of cloth.
• Adjust monitor settings.
• Adjust camera position if exposed to a strong light
source.
• Adjust the monitor's contrast level.
• Set the intermediate device, if in use, to 75Ω/ Hi-z
(refer to p.13).
• Check the power source for compliance with
specifications.
• Ensure that the feature is set to ON.
• Adjust and configure WHITE BAL.
• The camera may be facing the sun or a fluorescent
light. Adjust the position of the camera.
• The camera may be connected to a DC power
source. Connect to an AC power source.
• Check external SYNC signal frequency (should be
60Hz for NTSC, 50Hz for PAL).
•CAM ID : Assign ID number to the camera. It is restricted available to set ID from
1 to 255.
•DISP CAM ID: Displays camera ID on top left corner of the screen.
•BAUD RATE : Configure baud rate from 9600, 19200, 38400, 57600bps.
•UART MODE : Configure parity bit to NONE, EVEN, or ODD. Data bit is set to 8bit,
and stop bit to 1bit. Set the UART MODE to EVEN if using the
Remote Controller.
•RET PKT : Used to transfer a packet.
•END
IMAGE ADJ: Includes image quality or special function
factors.
•FREEZE: Use this feature to freeze capture an image.
•H-REV: Use this feature to horizontally inverse the screen.
•V-REV: Use this feature to vertically inverse the screen.
•SHARPNESS : Increasing this value sharpens object edges. Too high of a setting,
however, produces noise and may obscure the image.
•COLOR AGAIN : Adjusting this value affects the chroma level only; the burst level is
unaffected.
To finish setup menu.
RESET
EXIT
To reset your camera to factory default condition.
END: evert back to the USER PRESET menu.
Operating Your Camera