Sharp Aquos LC 37HV4U - Manual (Page 11)

10
System cable
AVC System (rear view)
AC cord
Display (rear view)
(GRAY) (WHITE)
Setting the System
After putting the Display and the AVC System in place, connect the system cables and AC cords. Use the
cable clamps for bundling the cables.
Preparation
Connecting the system cable and the AC cord to the Display
1
2
3
Removing the terminal cover
Connecting the system cable and the AC cord to the AVC System
CAUTION
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
AC CORD CONNECTED.
Press down the two
upper hooks to remove
the cover toward you.
Press the two hooks
toward the center of the
Display and remove the
cover toward you.
DISPLAY INPUT1 DISPLAY INPUT2
AC cord System cable
(GRAY)
Connect the plug firmly
until the hooks on both
sides click. (WHITE)
Connect the plug into
the terminal and secure
it by tightening the
thumb screws.