Sony Model CMT-CPX1 - Manual (Page 9)

T
une
r
9 GB
Tip
Press TUNING MODE to stop scanning.
Manual tuning preset
You can manually tune in and store the radio
frequency of the desired stations.
1
Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2
Press TUNING MODE repeatedly until
“AUTO” and “PRESET” disappear from
the display.
3
Press TUNING +/– repeatedly to tune in
the desired station.
4
Press TUNER MEMORY.
5
Press TUNING +/– repeatedly to select
the desired preset number.
6
Press ENTER.
7
Repeat steps 3 through 6 to preset
other stations.
Other Operations
To change the AM tuning interval
(except for European models)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding
TUNING –, press ?/1 on the unit. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the same
procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for about half a day
even if you disconnect the mains lead or if a power
failure occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
To Do this
Tune in a station
with a weak signal Follow the procedure described
in “Manual tuning preset”
(page 9).
Set another station
to the existing
preset number After step 4, press TUNING +/–
repeatedly to select the preset
number you want to store the
station.